Stripping
What should I do if the product ejection rubber is too close to the product?| Answer |
If the product ejection rubber is too close to the
product, you should place the product ejection rubber 1
inch (25mm) from the scrap cutting rule. |
How can I remedy Improper stripping rubber and location?
| Answer |
You can remedy improper stripping rubber and location by
replacing the stripping rubber. The rubber must
"roll" out of the scrap. |
What should I do if nicks are holding scrap to the blank?
| Answer |
If nicks are holding scrap to the blanks, you should
reknife the die to eliminate rule joints. The blank
could also be redesigned to eliminate rule joints. |
What should I do if there is improper blank design?
| Answer |
If there is an improper blank design, then the blank
should be redesigned. Eliminate square corners and
parallel sides in feed direction. |
The Dicar Logo, Boltless and the blue color of Dicar's die cutting blankets are trademarks and the name Dicar, Equalizer, Anvilok III, Equalok and Crushless are Registered Trademarks of Dicar, Inc.